NEVO-SKY JET BASIC CCT6 5.5

Description

Components of electronic set

controller
main harness
fuel level indicator
mounting accessories
pressure sensor
control panel

LINIA NEVO-SKY JET

NEVO-SKY JET LINE

It is dedicated to power units equipped with indirect fuel injection. The line is based on the new SKY platform dedicated to modern drive units. The NEVO-SKY JET line of controllers supports up to 8 cyl. This means a great convenience for assemblers, which will be able to use one software based on the SKY platform for all controllers offered by the NEVO-SKY family, including DIRECT controllers.

AUTO-SETUP in 5 steps

To facilitate installation and calibration, the NEVO-SKY family controllers have the AUTO-SETUP function, which in a simple and quick way helps in setting up most cars.

SKY EXPERT SYSTEM

The NEVO-SKY family, to which the JET product line belongs, cooperates with the NEVO-SKY software, which has been equipped with an advanced SKY EXPERT SYSTEM for automatic detection of irregularities in the settings and operation of the gas system. This system generates hints / warnings and suggests solutions. Each time a warning occurs, an audible signal is triggered so as not to miss the moment when the information is given. With each release of the SYSTEM EXPERT SKY program, the knowledge base is expanded to assist in car calibration.

Download NEVO-SKY JET products line card

Download NEVO-SKY JET electronics technical diagram

Download software

Additional information

number of cylinders [available versions]	6, 8
Operate with OBD Adapter	–
OBD parameters monitor	–
Automatic OBD errors reset	–
OBD system adaptation - OSA	–
Support reverse OBD correction	–
map on-board system adaptation - MOSA	+
Number of analog inputs, ie. Lambda Probe	5
Additional analog input in CCT6-D sensor	–
Number of outputs 12VOUT	2
RPM readings from camshaft sensor	+
Ability to work without connecting RPM wire	+
Decreasing of gas injection time for cold engine [cold VAG]	+
Fuel overlap [petrol-gas] during switching to gas	+
Configureable 3D correction maps for banks	+
Configureable correction of gas pressure	+
Dose correction for gas injectors / bank configuration	+
Master/Slave function	+
Gas injectors test	+
Reducer pressure letting off on cut-off	+
Gas injectors heating	+
Built-in fuel level emulator	–
Built-in fuel pressure emulator	–
Configurable engine temperature correction with OBD	–
SKY expert system [built-in]	+
Hydrophobic venting of CPU	+
Switch-over with low engine load	+
3D maps of adding petrol	+
Type of supported engines	MPI
Support for LPG and CNG	+
Start&Stop function	+
Preview of operating parameters with recorder	+
In the absence of gas, automatic return to gasoline and automatic switching to gas	+
Set the permissible number of emergency starts	+
Support vehicles after chip tuning [high power engines]	+
Pressure sensor	Analog
Dedicated inductive emulator	–
Kit elements	additional harness, basic harness, connection accessories, control panel, gas ECU, gas gauge, pressure sensor
Control panel	DG7

Products

Reliability build in