An unquestionable advantage of FENIX injectors is speed and short opening stable times. These injectors are also characterised by high stability of gas flowand very presise fuel dosage
in dynamic conditions. This is especially important for direct injection engines, due to their dynamic character.
In order to provide a high quality injector, KME being a producer of complete autogas systems, implemented necessary parameter control system, and also secured the right selection of components.

The product contains seals made of rubber-based mixtures (FKM) and modern fluoropolymer sliding coatings (non-stick and anti-freeze) that make the injector extremelly resistant to fuel pollution and low temperatures. The injector is equipped with a standard Superseal 2-pin connector.

When mounting FENIX injectors, you can use either manifoldsor dedicated elbows and knees. It is a very helpful tool for an installeras they facillitate mounting the injector, even in difficult to access areas.

Ø [mm]	1,0 [bar]	1,25 [bar]	1,5 [bar]
1,5 1,6 1,7	17÷23 HP | KM	19÷25 HP | KM	21÷28 HP | KM
1,8 1,9 2,0	24÷28 HP | KM	27÷32 HP | KM	31÷36 HP | KM
2,1 2,2 2,3	31÷35 HP | KM	35÷40 HP | KM	39÷45 HP | KM
2,4 2,5 2,6	37÷40 HP | KM	43÷46 HP | KM	48÷52 HP | KM
2,7 2,8 2,9 3,0	41÷45 HP | KM	47÷52 HP | KM	53÷59 HP | KM

The table shows the values of the injector nozzle diameter depending on the power output for one cylinder. Nozzle diameter selection values are approximate and suggested. In some cases they must be adjusted to the specific engine and system settings. Nozzle diameter selection values are approximate and suggested. In some cases they must be adjusted to the specific engine and system settings. We recommend using injectors with nozzles.